* Not rated for use with SRL's, Horizontal Lifelines, multiple users, Window Washing, Fall Arrest Side-Loading or Reverse-Loading. *

Best Price Guaranteed
Price: $6.95
    Item #SAS-1075
    Write a review!
    Quantity:

    Description

    Most roof anchor installations require the removal of shingles to install. This can pose a problem, especially on older roofs with brittle shingles. No need to remove the ridge cap to install fall arrest anchors because this flashing allows you to install anchors directly over your existing roofing material.

    The D- Minus anchor can be mounted directly over existing asphalt shingle roofs without removing any shingles. To cover the anchor and fasteners and protect it from the elements we invented the RetroFlash. It is a special metal flashing made from 20-gauge metal that slips under the course of roofing just above the anchor. It is held in place by the roofing material and the caulking used during installation. This product can be painted to match the color of the roofing material.

    • D- into Top-Chord/Truss: Simply center the anchor over the truss and nail or screw the anchor down securely.s
    • D- through Roof Decking into Backer-Board: Install our ¾” backer board under the current roof sheeting. Screw the D- Anchor through the roofing/decking and into the backer board

    Our 4-page Instruction/Specification Manual is very comprehensive and has the information needed to install the anchor and flashing system.

    Device: D-Single Direction Fall Arrest Anchor 

    Fall Protection Rating: Fall Arrest and Fall Restraint 

    Structure Attachment: Wood Structure 

    Min. Breaking Point: 5,000 lbs

    Connector Hole: 7/8" Diameter

    Material: 11 Gauge Powder Coated Steel or 11 Gauge 430 Stainless Steel 

    Dimensions: 2"x9-1/4"

    Max User Weight: 310 lbs max body weight with shock absorber 

    Working Radius: Direction of slope or 30-Degree 

    Hardware: Stainless Spiral Shank Nails or Stainless Steel Screws 2

    OSHA Standard: 1926:502, 1910.66

    ANSI Standard: Z359.1-07 and A10.32-2012

    Manual

    Specifications

    Material : 11 ga. powder coated steel
    PPE Connector Hole : 7/8 in. (22.22mm(
    Dimensions : 2 in. (50mm) x 9-1/4 in. (235mm)
    Fasteners : 6 required
    Minimum Breaking Strength : 5,000 lb. (22.5kN)

    Reviews (0) • Write a review!

    This product has no reviews yet. Write a review!