Kettle Accessories

Replacement regulator 1/4" Left-Hand fittings 30-60 PSI

1 1/2" Male Fitting On One End

For most equipment and tanker specifications 1/2" thread fitting Sizes: 4”, 6”, 12”, 18” & 24”

9/16" Left-Hand Swivel Nuts on Each End

15" stem length Wood handle and clip

Standard - Figure 200 2000psi/137.9 barFull Cast ConstructionSize: 1.5"

9/16" Left-Hand Swivel Nuts on Each End

Adjustable to fit different diameter pails Reusable Bail handle won't stick Affix to a 5-gallon plastic bucket and use as a supply bucket

2 inch thin wall tubing Used with 1-1/2 inch threaded nipple

No roofer should be without this valuable tool that helps prevent fires through easy cleaning of the inside and outside of kettles. It's heavy duty construction allows for many years of use. Size 10" x 12" x 1/2" with a 40" or 72" handle.

9/16" Left-Hand Swivel Nuts on Each End

RACE 5 Gallon Asphalt Bucket-Buckets are all steel, with round bottoms to prevent sticking to roof; features a 'D' type lower handle and a heavy ball type top handle that cannot fall against side.

9/16" Left-Hand Swivel Nuts on Each End

9/16" Left-Hand Swivel Nuts on Each End

Standard Wrench Type UnionInternational FittingBrass to Iron Seat, Class 150Size: 1 1/2" Union Brass Seat BlkMaterial: Malleable IronWeight: 2 lbs

Heat Resistant Rubber, 1 1/2" Male Fitting On One End

Roll of Silicone Rubber Listing Tape (1" x 1/8" x 30')

2 inch thin wall tubing Used with 1-1/2 inch threaded nipple

2 inch thin wall tubing Used with 1-1/2 inch threaded nipple

2 inch thin wall tubing Used with 1-1/2 inch threaded nipple

No roofer should be without this valuable tool that helps prevent fires through easy cleaning of the inside and outside of kettles. It's heavy duty construction allows for many years of use. Size 10" x 12" x 1/2" with a 40" or 72" handle.

Clamps hot pipe to guard rail Comes with eyelet for kettle rope

2 inch thin wall tubing Used with 1-1/2 inch threaded nipple

Features:Independent lab verification that fittings meet applicable chemical & physical properties100% air testedFM approved at 300 lbs.

The Hot Material Packer is an independent piece of equipment which is insulated to maintain material at proper temperatures. The Hot Material Packer can be used to carry hot material to locations not easily accessible by other kettles and can be readily moved to any rooftop using a sturdy lifting crane. This can also be used as a material applicator with miner factory modifications. Specifications: 100 us gal cap 36” diameter x 55” tall Comes with or without wheels ...

The Hot Material Packer is an independent piece of equipment which is insulated to maintain material at proper temperatures. The Hot Material Packer can be used to carry hot material to locations not easily accessible by other kettles and can be readily moved to any rooftop using a sturdy lifting crane. This can also be used as a material applicator with miner factory modifications. Specifications: 100 us gal cap 36” diameter x 55” tall Comes with or without wheels ...