Best Sellers

S-5 SnowClip II
SnoClip™ is added to retard the migration of snow and ice beneath the crossmembers.
Price: $2.65

SnoClip™ is an aluminum add-on that helps retard the migration of snow and ice beneath either the ColorGard® crossmember, or the SnoRod™ of a SnoRail™ or SnoFence™ system. It has a special integrated rubber "foot" to prevent abrasion of the panel's finish. SnoClip™ snaps to the back of the crossmember or rod and extends down to the flat of the roofing panel.

S-5 SnowClip III
Retards the migration of snow and ice beneath the crossmembers. For seam heights of...
Price: $2.99

SnoClip™ is an aluminum add-on that helps retard the migration of snow and ice beneath either the ColorGard® crossmember, or the SnoRod™ of a SnoRail™ or SnoFence™ system. It has a special integrated rubber "foot" to prevent abrasion of the panel's finish. SnoClip™ snaps to the back of the crossmember or rod and extends down to the flat of the roofing panel.

SnoBlox Deuce Snow Guard
Made in America!
Price: $2.50

The American made SnoBlox Deuce has revolutionized the polycarbonate snow guard industry with its low profile forward mounted 2.5" high face and its sleek 1.5" wide waffled tapered back base that fits most roof panels without rib straddling. This patented product has stood the test of time and is an aesthetically appealing, low cost solution to the problem of sliding snow and ice on metal roofing. It's mounting versatility allows it to be mechanically attached on screw down roofs with a 1.5"...

S-5 ColorGard Un-Punched, 8ft Piece w/Splice
Use Unpunched when the roof has untrue seam width or seam width is not divisible by 4.
Price: $21.95

Unpunched ColorGard® is the most versatile and easy to install, when used with the S-5!™ VersaClip™. Unpunched does not need holes, as the VersaClip™ accommodates any seam spacing. The unpunched configuration works well with VersaBracket™. Unpunched is the right choice when the roof is laid out with untrue seam width or when the seam width is not divisible by 4. If in doubt, use unpunched. Included with crossmembers, use the Splice to join two pieces of...