Albion E18T600 Cordless Multi-Component Cartridge Gun - 600 Series, 1:1 & 2:1

The Albion E18T600 is an 18-volt cordless multi-component dispenser for 600 mL side-by-side cartridges in 1:1 or 2:1 mix ratios. A variable-speed trigger and top flow dial regulate output through static mixers, while auto-reverse briefly backs off pressure at release to cut ooze and stringing. The synchronized twin plungers and rigid frame help maintain mix accuracy, delivering uniform, fully mixed beads with epoxies, acrylics/MMA, and polyurethanes. Designed for daily jobsite use, the E18T600 reduces hand fatigue versus manual drives and streamlines staging with a ladder hook and comfortable, balanced grip.

Key Features:

• 18V cordless drive with variable-speed trigger and top flow dial
• Auto-reverse anti-drip to minimize ooze at starts and stops
• Accepts 600 mL side-by-side cartridges in 1:1 and 2:1 ratios
• Rigid frame with synchronized plungers for consistent mixing
• Uses standard static mixers and retaining nuts supplied with the cartridge

• Model/MPN: E18T600
• Type/Line: Cordless multi-component (dual-cartridge) dispenser
• Capacity: 600 mL total (typ. 1:1 = 300 × 300 mL; 2:1 ≈ 400 × 200 mL; cartridge dependent)
• Mix Ratios: 1:1 and 2:1 side-by-side
• Power: 18V Li-ion (battery/charger availability varies by kit)
• Speed Control: Variable-speed trigger with flow/speed dial; auto-reverse anti-drip
• Interface: Standard static mixer and retaining nut (per cartridge manufacturer)
• Applications: Two-part epoxies, acrylics/MMA, polyurethanes, structural/anchoring adhesives
• Includes: E18T600 cordless gun (tool-only in most configurations; battery/charger, cartridges, and mixers sold separately)

• Charge and install the correct 18V battery; confirm trigger and forward/reverse operation.
• Verify cartridge ratio (1:1 or 2:1) and select the manufacturer-specified static mixer and retaining nut.
• Retract the rod; seat the 600 mL side-by-side cartridge fully with outlet ports aligned.
• Attach the retaining nut and static mixer; tighten per cartridge instructions.
• Set flow dial low and prime with brief trigger pulls until both components reach the mixer; purge a small amount for a uniform, fully mixed stream.
• Apply a steady bead, adjusting trigger/dial for viscosity and nozzle size. Relieve pressure when pausing; cap or replace the mixer and clean hardware after use.

Q: Which cartridges does the E18T600 accept?
A: 600 mL side-by-side dual cartridges in 1:1 and 2:1 mix ratios (confirm dimensions with your cartridge supplier).

Q: Does it have anti-drip control?
A: Yes. Auto-reverse briefly backs off pressure at trigger release to reduce ooze and stringing.

Q: What mixers does it use?
A: The static mixer and retaining nut specified by the adhesive/cartridge manufacturer.

Q: Is a battery and charger included?
A: Many configurations are tool-only; availability of battery/charger depends on the kit. Check the specific package contents.

Q: What materials are typical?
A: Two-part epoxies, acrylics/MMA, polyurethanes, and other structural or construction adhesives—verify compatibility with the manufacturer.