OMG, #RBM003 Heat Sink Magnets- 6PK

RBM003 is a set of six Heat Sink Magnets for the OMG RhinoBond system, used immediately after each induction weld to ensure a strong, consistent bond. These magnets transfer heat away from the welded plate to allow proper curing and reduce membrane movement. The polymer body and magnet design are optimized for alignment, heat dissipation, and field durability.

Key Features

• six magnets included so multiple welds can be held down at once
• made of a proprietary polymer to improve thermal transfer
• helps maintain bond integrity by holding down plate for up to 45 seconds after weld cycle
• alignment covers full plate to avoid misalignment issues
• designed to be cleaned frequently to avoid debris damaging membrane

• item number: RBM003 (6-pack)
• quantity: 6 heat sink magnets per pack
• material: proprietary polymer body with magnetic core
• usage time: hold magnet over weld for up to 45 seconds after welding cycle
• function: transfer heat from welded plate to ambient air to promote strong bond
• alignment: magnet must completely cover the RhinoBond plate after welding to achieve proper bond
• maintenance: keep bottom of magnet clean; wipe off metal strands or debris before use

• Complete the RhinoBond induction weld over the specially coated plate.
• Immediately place a heat sink magnet over the welded plate, ensuring it fully covers the plate’s surface.
• Hold the magnet in place for up to 45 seconds to allow the bond to strengthen.
• After removal, inspect the magnet’s bottom and wipe away any debris or metal shards.
• Continue welding other plates, using additional magnets as needed so you don’t have to walk back to reused magnets frequently.
• Store the magnets clean and dry; avoid impacts or exposure that could damage the polymer body or magnetic strength.

Q: What are these magnets used for?
A: They are used after a RhinoBond weld to hold the plate in place and help dissipate heat, ensuring a strong bond.

Q: How many magnets come in one RBM003 pack?
A: Six magnets.

Q: How long should the magnet be held over the weld?
A: Up to 45 seconds immediately following the weld cycle.

Q: Why is alignment important?
A: If the magnet does not fully cover the plate, the bond may be weaker or inconsistent.

Q: How should the magnets be maintained?
A: Wipe off metal strands or debris from the bottom of the magnets before each use to avoid damaging the membrane.