Albion DL-45-T13E 18V Core Cordless Bulk Gun - 20 oz Motorized Caulking Dispenser

The Albion DL-45-T13E Core Cordless Bulk Gun pairs an 18V motor drive with a rotating 2-inch steel barrel to deliver smooth, repeatable flow from 20 oz bulk loads. A variable-speed trigger and flow dial control bead size, while auto-reverse briefly backs off pressure to minimize ooze at stops. The threaded steel front cap accepts the standard 1/2-inch metal nozzle for a tight, leak-resistant connection, and the rigid frame keeps the plunger aligned for clean starts and consistent placement across long runs, corners, and hard-to-reach details. Built for daily use, the DL-45-T13E reduces hand fatigue and speeds production on high-volume sealing.

Key Features:

• 18V cordless drive with variable-speed trigger and flow dial
• Auto-reverse anti-drip reduces ooze at starts/stops
• Rotating 2" steel barrel improves access and bead orientation
• Threaded steel front cap with standard 1/2" metal nozzle
• Rigid frame for precise plunger alignment and consistent flow

• Model/MPN: DL-45-T13E
• Type/Line: Core cordless manual bulk gun (motorized)
  
• Capacity: 20 oz (approx. 1.5 pint) bulk loads
  
• Power: 18V Li-ion (battery/charger sold separately; platform per kit)
  
• Barrel: 2" diameter steel; rotating
  
• Speed Control: Variable-speed trigger with flow dial
  
• Anti-Drip: Auto-reverse pressure relief at trigger release
  
• Nozzle Interface: Threaded steel front cap; standard 1/2" metal nozzle
  
• Typical Use: High-volume sealing with bulk materials
  
• Includes: DL-45-T13E tool with threaded front cap and 1/2" metal nozzle (battery/charger not included)

• Charge and install the correct 18V battery; confirm forward/reverse operation.
• Retract the rod; remove front cap/nozzle and verify ejector is installed.
• Bulk-load from pail (or with a loading sleeve), drawing material until filled; keep nozzle end upright.
• Reinstall the threaded front cap and 1/2" metal nozzle; tighten securely.
• Set flow dial low; prime with short trigger pulls until a steady stream forms, then test on scrap and adjust speed.
• Dispense with steady travel; allow auto-reverse to stop flow at bead ends. Relieve pressure and clean before cure.

Q: Is a battery and charger included?
A: No. The DL-45-T13E is typically sold tool-only; use the appropriate 18V Li-ion battery and charger per kit/platform.

Q: What capacity does it handle?
A: 20 oz bulk loads in a rotating 2" steel barrel.

Q: Does it have anti-drip?
A: Yes. Auto-reverse briefly backs off pressure at trigger release to reduce ooze.

Q: What nozzle connection is used?
A: A threaded steel front cap accepts the standard 1/2" metal nozzle.

Q: How does it differ from the DL-45-T13 manual version?
A: The DL-45-T13E uses an 18V motorized drive for reduced hand effort and finer speed control.