S-5-CANDUIT 2"

The S-5! CanDuit Clamp 2″ is part of the CanDuit securement clamp line. It uses an electro-zinc coated steel strap with an EPDM liner to protect both pipe/conduit and metal roof panel surfaces. It features an M8 threaded shaft that mounts directly to S-5! clamps or brackets. Size 2″ accommodates piping or conduit with an outer diameter in the range of approximately 2.30″ to 2.60″. It is durable, corrosion-resistant, and comes with a 10-year warranty.

Key Features:

• Electro-zinc coated steel strap with EPDM liner to prevent abrasion
• M8 threaded shaft for mounting to S-5! clamps or brackets
• Designed for approx. 2.30″-2.60″ outer diameter pipe/conduit
• Protects roof panel finish while securing conduit runs
• 10-year manufacturer’s warranty

• Material: Electro-zinc coated steel strap, EPDM liner pad
• Strap coating: Minimum 8-micron electro-zinc
• Threaded shaft: M8 stud mount
• Fit range (outer diameter): ~2.30″ to ~2.60″ (58–66 mm)
• Available sizes in series: 14 clamp sizes from ~0.79″ up to ~4.60″ OD
• Warranty: 10 years against manufacturer defects
• Includes: One CanDuit Clamp 2″ unit (strap + EPDM liner + M8 shaft)

• Measure the outer diameter of the pipe or conduit to ensure it falls between ~2.30″ and ~2.60″.
• Install a compatible S-5! clamp or bracket where the CanDuit’s M8 shaft will attach.
• Wrap the strap around the pipe with the EPDM liner between the strap and pipe surface.
• Align the clamp so it sits without twisting; ensure liner pad is fully seated.
• Thread the M8 shaft into the base clamp or bracket and secure properly.
• Inspect for secure fit, check that the liner is properly installed, and that no damage to roof or pipe finishes has occurred.

Q: What OD does the 2″ CanDuit clamp support?
A: Approximately 2.30″ to 2.60″ (58–66 mm).

Q: Is hardware included for mounting?
A: The clamp includes the strap, liner, and M8 shaft; a flange nut or other securing nut may need to be supplied depending on the bracket.

Q: Can this clamp be used for heavy loads (snow, etc.)?
A: No, it is intended for securing conduit or pipes, not for structural snow loads.

Q: How long is the warranty for the CanDuit line?
A: 10 years against manufacturing defects.