Ivy Classic 40180 - 14 x 1/8 x 20mm Metal Cut Off Blade

Built for fast, straight, and dependable cuts, this reinforced 14" metal cut-off wheel powers through steel, rebar, angle iron, and pipe with clean kerfs and minimal burring. The 1/8" thickness balances cutting speed and wheel life, while the 20 mm arbor fits common chop saws and stationary cut-off machines for shop and jobsite reliability.

Key Features

• Reinforced, fast-cutting abrasive for consistent, straight cuts in ferrous metals.
• 14" diameter with 1/8" kerf: strong balance of speed, control, and service life.
• 20 mm arbor to fit popular chop saws and stationary cut-off tools.
• Optimized bond resists glazing and premature wear under sustained loads.
• Stable, low-vibration performance for cleaner edges and reduced rework.
• Ideal for steel stock, rebar, angle iron, conduit, and pipe fabrication.
• Shop-ready durability for fabrication, maintenance, and construction tasks.

Product Type: Reinforced abrasive cut-off wheel (stationary chop saw)

Weight: ~14–20 oz (single wheel; approximate)

Dimensions: 14" diameter × 1/8" thickness × 20 mm arbor

Diameter: 14" (355.6 mm)

Thickness (Kerf): 1/8" (3.2 mm)

Arbor Size: 20 mm

Material (Abrasive): Aluminum oxide composite

Reinforcement: Fiberglass mesh

Bond Type: Resinoid, fast-cut formulation

Max RPM: 4,400–4,800 RPM (typical for 14" chop saws; use saw’s rated speed)

Cutting Direction: Dry cut (no coolant required)

Tool Compatibility: 14" stationary chop saws / cut-off machines with 20 mm arbor

Applications: Steel, rebar, angle iron, conduit, pipe, and general ferrous metals

Performance Notes: Optimized for straight, fast cuts with stable, low-vibration tracking

Operating Guidance: Let the wheel reach full speed, use steady feed pressure, avoid side-loading; replace if glazed, cracked, or under diameter limit

Safety Standards: Use ANSI-compliant eye/face/hand protection; install guards per tool manual

Included: One 14" x 1/8" x 20 mm metal cut-off wheel

Q: Will this 14" x 1/8" x 20 mm wheel fit my chop saw?
A: Yes—if your saw uses a 14" wheel with a 20 mm arbor. Always confirm arbor size and guard clearance before mounting.

Q: What metals is this blade designed to cut?
A: Ferrous metals like mild steel, rebar, angle iron, conduit, and pipe. It’s not for stainless, aluminum, or non-ferrous unless specified by the tool and wheel labeling.

Q: What speed should I run it at?
A: Use the saw’s rated speed within the wheel’s maximum RPM (typical 4,400–4,800 RPM for 14"). Never exceed the wheel’s max RPM.

Q: How do I get the best life and straightest cuts?
A: Let the wheel reach full speed, feed steadily (don’t force it), avoid side pressure, and replace the disc if it’s glazed, cracked, or worn past the minimum diameter.