Surf X Flush - 1 gallon

Surf X Flush 2000™ is a powerful cleaning formula designed for flushing and immersion cleaning of spray equipment, metering systems, and feed lines. It loosens and removes cured urethane foam, adhesive, and resin deposits. The solution is also effective at cleaning polymer overspray, coatings, and industrial resins.

Key features:

• Effective for immersion and flushing of spray systems
• Removes cured urethane foam, adhesives, and resin build-up
• Compatible with polyurethane, epoxy, acrylic, and coatings
• Safe on most elastomers and metal substrates
• Improves bath life and reduces disposal costs

• Weight: 12 lbs 
• Dimensions: 7 in × 4 in × 11.5 in 
• Application: Flushing and immersion cleaning of spray equipment, removing cured foam, resins, and coatings 
• Chemical types removed: Polyurethane foam, adhesives, polyols, isocyanates, industrial resins, coatings (aliphatic, epoxy, acrylic, varnish)

Warning:

• This item is Hazmat

• Ensure the spray-foam or coating equipment is turned off and depressurized. Disconnect air and power supply before beginning. 
• Pour or pump SURF X Flush into the system’s reservoir, lines, or immersion bath according to the manufacturer’s instructions. 
• Recirculate the solvent through hoses, pumps, spray guns or immersion parts until the discharge runs clear and all resin or foam deposits are removed. Use full-strength, room temperature solution. 
• Once the system is cleaned, flush with a clean compatible solvent or water rinse if required, then purge the system with the appropriate storage fluid if applicable. 
• Store the product in its sealed container in a cool, dry place away from direct heat or ignition sources. Dispose of spent solvent according to local regulations. 

Q: What types of deposits can SURF X Flush remove?
A: It removes cured polyurethane foam, adhesives, resin build-up, coatings like epoxy or acrylic, and is effective in flushing spray-foam equipment.

Q: Is this product safe to use on elastomers and metal substrates in equipment?
A: Yes — the formula is designed to be safe on most elastomers, gaskets, seals and metal substrates when used as directed.

Q: Can I heat the solvent to accelerate cleaning during flushing?
A: No — use at room temperature or up to the manufacturer-stated maximum (around 140-150 °F) to avoid degradation or unsafe conditions.

Q: How should I dispose of spent cleaning solvent?
A: Dispose in compliance with local environmental regulations; never reuse solvent contaminated with reactive foam residues.

Q: Does the cleaner contain hazardous chlorinated solvents or high VOCs?
A: No — it is formulated to be non-HAPs, non-flammable, non-chlorinated and meets many regulatory requirements.