ACRO - Roof Bracket 60°, 2" x 8" 19" Back Length, 29608

The ACRO 29608 Roof Bracket is a contractor-grade, 60° angled support bracket with a generous 19″ back plate, specifically designed for use with structurally sound 2×8 lumber planks. It includes four OSHA-compliant offset nail slots to prevent upward slippage, reinforced with six long welds, a back-stiffening rib, and a welded gusset to provide exceptional strength and resistance to twisting or bending. The bracket’s smooth, rounded edges protect hands and roofing materials, and its powder-coated safety-yellow finish ensures durability and visibility on the job. It installs and removes cleanly without damaging shingles and, when spaced correctly—no more than 8 ft apart—it supports one worker plus up to 40 lb of materials per 4-ft staging span.

Key Features:
• Four offset OSHA-compliant nail slots for secure installation
• Six long welds, back-stiffening rib, and welded gusset for structural strength
• Smooth, rounded edges safeguard hands and roof surfaces
• Installs and removes cleanly, preserving shingles
• Supports one worker plus up to 40 lb per 4-ft span when spaced properly

• Model: 29608 – 2″ × 8″ Roof Bracket at 60° angle, 19″ back plate
• Compatible plank size: 2×8 lumber
• Nail slots: Four offset slots exceeding OSHA minimum
• Structural reinforcement: Back-stiffening rib, welded gusset, six welds
• Load capacity: One worker plus 40 lb of material per 4-ft span
• Installation spacing: Maximum 8 ft between brackets
• Finish: Powder-coated safety-yellow

• Position the bracket on the roof slope over structural decking at the desired location.
• Drive nails through all four offset slots into the roofing deck to secure the bracket.
• Confirm that the bracket is level and properly seated.
• Insert a structurally sound 2×8 plank into the heel of the bracket for staging.
• Install additional brackets spaced at intervals of no more than 8 ft and lay planks across them to create a platform.
• Verify the stability and safety of the staging before use.

Q: What plank size does this bracket support?
A: It is designed for structurally sound 2×8 lumber planks.

Q: Why are there four nail slots?
A: Four offset nail slots exceed OSHA’s minimum requirement and help prevent the bracket from sliding upward.

Q: Does installation damage shingles?
A: No—the smooth edges and design allow installation and removal without harming shingles.

Q: What spacing is recommended for staging?
A: No more than 8 ft apart between brackets ensures safe support.

Q: What load can each bracket carry?
A: Each bracket supports one worker plus up to 40 lb of materials per 4-ft staging span.