Powerblanket 55 gallon Drum Heater with Rapid Ramp Technology

The Powerblanket BH55-RR is a 55-gallon full-wrap drum heater with a fixed internal thermostat preset to approximately 100°F. It uses Rapid Ramp Technology so that it initially draws more power to reach the preset temperature then cycles down to maintain it. Designed for both steel and poly drums, it delivers uniform heat, durability, and safety for demanding industrial conditions.

Key Features:

• Fixed internal thermostat preset to ~100°F (±10°F)
• Rapid Ramp mode: initially full power, then reduced to maintain temperature
• Insulated full-wrap design with cinch straps for secure fit
• Compatible with steel or plastic 55-gal drums
• ETL / UL / CSA / CE certified safety standards

• Fits container size: 55 gallon / 208 L
• Container dimensions: 23.3″ diameter × 34.9″ height (59 cm × 89 cm)
• Thermostat type: Fixed internal preset (~100°F ±10°F / 38°C ±5°C)
• Voltage: 120 V
• Watts (initial / maintenance): 800 W initial, 400 W to maintain (after ramp-up)
• Amperage: 6.67 A initial, ~3.33 A maintenance
• Heated dimensions: 82″ length × 36″ height
• Heated area: 20.50 sq ft
• Plug type: 15 AMP plug
• Approximate weight: 11 lbs / 5 kg
• Maximum vinyl exposure temperature: 180°F / 80°C
• Minimum vinyl exposure temperature: -15°F / -20°C
• Certifications: ETL, UL, CSA, CE

• Wrap the BH55-RR blanket fully around the 55-gallon drum so the insulated surface covers the entire drum.
• Secure it using the cinch straps to ensure a snug, uniform fit.
• Plug into a grounded 120 V outlet using a 15 AMP plug.
• The Rapid Ramp preset quickly heats up to ~100°F, then power reduces to maintain that temperature.
• Monitor the heater to ensure straps remain tight and the drum is evenly heated.
• After use, disconnect power, allow the heater to cool, clean off any residues, and store flat or loosely rolled.

Q: What is the temperature preset for BH55-RR fixed thermostat models?
A: Approximately 100°F ±10°F.

Q: How much power does the unit draw during ramp-up and maintenance phases?
A: Initial draw is about 800 W, reduced to ~400 W once temperature is reached.

Q: Can it be used on plastic (poly) drums as well as steel?
A: Yes, it is compatible with both steel and poly 55-gal drums.

Q: What safety certifications are included?
A: Certified to ETL, UL, CSA, and CE safety standards.

Q: What are the temperature exposure limits for the vinyl shell?
A: Maximum exposure of about 180°F / 80°C and minimum of -15°F / -20°C.