Malco, SRT2 SideSwiper Siding Tool

The Malco SRT2 SideSwiper® II Siding Tool is designed to unlock and separate vinyl siding panels for repair, replacement, or installation. The angled hook blade slides under the siding panel and disengages the interlocking seam, allowing access to the nail strip without damaging the material. Its straight handle and smooth unlocking motion provide controlled operation during siding removal and reinstallation.

Key Features

• Unlocks and separates interlocking vinyl siding panels
• Burr-free hook design for smooth disengagement
• Angled blade keeps wrist straight and knuckles clear of work surface
• Blade plating helps prevent cutting or shaving vinyl material
• One-piece spring steel construction for durability
• Non-slip textured handle for improved grip and control
• Can also assist with re-locking siding panels after installation

1. INSERTION: Wedge tip of blade under overlapping panel and hook onto the back lip of buttlock.
2. UNLOCKING: Pulling lip downward, slide the tool along the length of panel to unlock and expose nail row of panel to be removed.
3. PANEL REPLACEMENT: Lock and nail replacement panel into place. Use tool to re-lock overlapping panel. Pull down on panel lip and press it into lock of replacement panel below.

Model: SRT2

Type: Vinyl siding removal/unlocking tool

Construction: One-piece spring steel

Blade Design: Angled hook with plated finish

Handle: Straight, non-slip textured grip

Application: Vinyl siding panel removal and reinstallation

Operation: Manual sliding/unlocking action

Q: Why is it hard to get the tool under the siding to start?
A: Getting started can take a bit of effort because the tool needs to hook onto the back lip of the siding. Once it’s properly engaged, it will slide more easily along the panel.

Q: Can this be used to reinstall siding as well as remove it?
A: Yes, after installing a replacement panel, the tool can be used to pull down the upper panel and snap it back into the locking seam.

Q: What usually causes the siding to not unlock smoothly?
A: This typically happens when the hook is not fully engaged on the panel lip or when the tool is pulled outward instead of being slid along the seam.