DESIGNED FOR THE FLOORING INDUSTRY
Concrete Encounter CME 4 is for measuring moisture content instantly in concrete floors and floor screeds without the need to drill or damage the surface.
SCREEDS AND CONCRETE FLOORS MUST BE DRY BEFORE THE FLOOR COVERING IS INSTALLED
Regular checking of moisture content during the drying out period of a new concrete floor or floor screed is important to ensure it has reached sufficient dryness to accept the floor covering.
Excess moisture in the concrete could cause latent problems such as condensation or failure of the adhesive under the floor covering
The Concrete Encounter will give you an instant reading of moisture content to over 6% for concrete and 0 to 10 comparative for Gypsum floor screeds enabling you to make an informed decision on when to install the floor covering
To use, simply switch on and press down the instrument firmly against the surface. As many non-destructive tests as you need can be carried out in seconds without the need to drill or damage the concrete.
FEATURES
Instant Readings
Non-destructive in operation
No need to probe or drill or mechanically damage the surface
Reproducible results
Battery Operated
Pocket Sized
Clear, easy to read analog dial
Strong, robust, electrodes and body
Hold reading function
DESIGNED FOR THE FLOORING INDUSTRY
Tramex has been designing, manufacturing and marketing worldwide, non-destructive moisture meters for more than 30 years. You can, therefore, purchase with confidence that you are getting the latest, most practical and useful moisture measurement instrument available to the flooring industry. Recommended by many leading manufacturers of floor covering materials and flooring adhesives.
WARRANTY
The Concrete Encounter carries a full parts and labour warranty for a period of one year from the date of first purchase. In addition the purchaser is entitles to a full refund if the instrument does not give full satisfaction and is returned in original condition within 30 days of purchase.
Product Design:
The Concrete Encounter CME 4 is a hand-held electronic moisture meter operating on the principle of non-destructive impedance measurement. Parallel co-planer electrodes are mounted on the base which, during operation, transmit low-frequency signals into the concrete floor screed to a depth of approx. 12.5mm (.5 inch).
While concrete under normal conditions can never be completely dry, the instrument has been calibrated on acceptably dry material. In operation it compares the change in impedance caused by the presence of dampness and displays this on a clear, easy to read analog dial.
Operating Procedure:
To carry out moisture tests simply brush any dust from a smooth area of concrete and also from electrodes, switch on the Concrete Encounter, place CME 4 firmly onto the surface, fully compressing the spring loaded signal enhancing contacts on the base of the CME 4. Read the moisture content from the clear analog dial.
The CME 4 is calibrated to give percentage moisture content reading on a clean, bare dust free concrete floor slab, thus reading taken on concrete slabs through paint, coatings, adhesives or other material on the surface of the slab should be regarded as qualitative or comparative and not quantitative.
DON'T TAKE RISKS WITH EXCESS MOISTURE!!
Moisture test before you install a floor covering.
Excess moisture in concrete substrate can cause costly problems for the installer. Avoid the risk of having these problems and floor failures by testing for excess moisture before installing a floor. Test the fast, easy, clean and non-destructive way with the Tramex Concrete Encounter CME 4.