Roller Mop Roller 18 in. x 1.25"

The RACE Roller Mop Roller 18 in × 1.25 in is a replacement roller designed for roofing and waterproofing coatings. It features a 1¼ inch nap and is built on a steel frame for durability. This roller requires a roller mop frame, pin-type adapter, and compatible mop handle to function properly.

Key features:

• 18-inch roller length with 1.25-inch nap
• Steel frame construction
• Suitable for all types of coating materials
• Requires roller mop frame, pin-type adapter, and compatible handle
• Designed for roofing and waterproofing applications

• SKU: 100-1470
• Dimensions: 18 in length × 1.25 in nap
• Frame material: steel
• Compatibility: pin-type roller mop frames and handles
• Suitable for: roofing and waterproofing coatings

• Remove the old roller from the frame by pulling off the end cap and sliding the roller out of the steel frame. Confirm the frame and pins are clean and free of old material build-up.
• Select the replacement roller (18 in length, 1.25 in nap) and align the pin-type adapter holes with the frame’s pins. Slide the roller into place and install the end cap, securing the roller firmly in the frame. 
• Attach a compatible handle to the roller-mop frame and assemble on the job site. Check that the roller rotates freely and the nap is intact without damage. 
• Dip or load the roller with coating, apply evenly across the membrane or substrate using steady pressure. Use overlapping passes to ensure full coverage and avoid ridges. 
• After use, clean excess coating from the roller and frame, inspect the nap for wear or clumping, and store the roller lying flat or hung in a dry area until next use.

Q: What material builds or substrates is this roller designed for?
A: It is built for roofing and waterproofing coatings, where consistent nap and width matter for full surface coverage.

Q: How do I ensure the roller applies coating evenly without ridges or missed spots?
A: Use overlapping passes, maintain consistent pressure, keep nap fully loaded, and inspect for even film build rather than wiping.

Q: When should I replace the roller nap rather than clean it?
A: If the nap is matted, missing fibers, or shows uneven wear that causes streaking or film thinning, then replace rather than continue cleaning.

Q: What handle and frame compatibility should I verify before installing?
A: Confirm the frame uses a pin-type adapter sized for the 18 in roller and that the handle is rigid and long enough for your surface and reach.

Q: How should I clean and store the roller after coating application?
A: Remove excess coating, rinse or wipe the frame and nap clean, check for damage, and store in a dry location off the ground to preserve nap integrity.