Everhard MR13500 - Aluminum Vee Roller

Purpose-built for tight detail work, the MR13500 uses a lightweight, corrosion-resistant aluminum V-profile wheel that nests into inside corners, ribs, and channels where flat rollers can’t reach. The V shape focuses pressure right in the angle for crisp, uniform consolidation on single-ply membranes, while a rigid frame and smooth bearings keep tracking precise and chatter-free. Comfortable in hand and tough enough for daily use, it’s a go-to finisher for corners, step-downs, and change-of-plane seams on TPO, PVC, and EPDM.

Key Features

• Aluminum V-profile wheel concentrates pressure in angles and grooves for clean, consistent weld finishing
• Non-marring, corrosion-resistant construction that performs well around heat-welded seams
• Smooth, enclosed bearings for low-drag rolling and long service life
• Rigid single-fork frame keeps hardware out of the contact path for accurate control in tight spaces
• Ergonomic 5″-class handle provides a secure grip and knuckle clearance near walls and curbs
• Lightweight feel reduces fatigue during repetitive detail passes
• Jobsite-ready durability designed for daily professional roofing use
• Made in the USA quality consistent with Everhard’s roofing tool lineup

Roller Diameter: 2″ (50.8 mm)

Roller Width: 1/2″ (12.7 mm)

Profile: V-groove wheel for nesting into corners, ribs, and channels

Edge Geometry: Hubs taper to a ~5/64″ rounded edge to help prevent membrane cutting

Roller Material: Lightweight, corrosion-resistant aluminum (non-marring)

Frame/Forks: Stable double-fork steel frame for precise tracking

Bearings: Enclosed ball-bearing action for smooth, low-drag rolling

Handle: 5″ wood handle with comfortable, secure grip

Overall Length (approx.): ~8.5″

Weight (approx.): ~0.380 lb (0.17 kg)

Intended Use: Detail finishing on TPO, PVC, EPDM—inside corners, step-downs, change-of-plane seams

Origin: Made in USA

• Grip the 5″ hardwood handle firmly to maintain control.
• Position the aluminum “V” roller tip into the seam, flashing, or tight angle you want to press.
• Roll forward steadily with even pressure to embed adhesive or bond the membrane.
• Roll backward if needed to reinforce adhesion or close any gaps.
• Use the tapered hub edges to avoid damaging adjacent membrane areas.
• After use, wipe off any adhesive, debris, or residue from the roller surface.
• Store the detail roller in a dry, protected spot to preserve the aluminum and bearings.

Q: What is the MR13500 used for?
A: Finishing tight detail areas—inside corners, change-of-plane seams, ribs, and channels—where a flat roller can’t reach. The V profile focuses pressure right in the angle for crisp, uniform consolidation on TPO, PVC, and EPDM.

Q: Why choose an aluminum V roller over brass or nylon?
A: Aluminum is lightweight and corrosion-resistant, so it reduces hand fatigue and performs well around heat-welded seams without marring finished surfaces. Brass carries more mass/heat for certain finishes, while nylon is the most forgiving on delicate surfaces—MR13500 balances control, durability, and light feel.

Q: What are the key size, weight, and build details?
A: The V wheel is about 2″ in diameter × 1/2″ in width, mounted on a stable double-fork frame with enclosed bearings and a 5″ wood handle. Tool weight is roughly 0.38 lb (0.17 kg).

Q: Any tips for best results and care?
A: Use light-to-moderate, steady passes and let the V track the corner—don’t force it. Keep the wheel clean, protect bearings from debris, wipe down after use, and store the tool dry to maximize service life.