Tips

Recommend after using 0.625" tip and it feels a little messy, or runny. This will help constrict that loose material a small amount delivering a more consistent "dollop" every time with less material wasted. Often used during the heat of the day when material heats up and becomes looser. As always take the tip out to draw material then twist the tip back in 4 or 5 revolutions (No need to over tighten).

Great for butter grades, Fastener grade mastics. Often the second choice for sealing fasteners if the .47 tip feels to slow or having to push too hard. Take the tip out to draw the material, screw it back in (4-5 turns) and you are ready to seal some leaky fasteners. If the material you are using feels too messy with this tip, consider trying the smaller .47" tip. If the material feels too slow coming out of this tip, try out 1.0" Seam sealer tip (yes even if you are still trying to seal...

This unusual tip is for spreading top coat. Nail your coverage rates and Millage every time. Evenly dispense your material with this five fingered tip... This tip will surprise you how much easier It is then the traditional Dump and slop method out of a 5 gallon bucket... A perfectly full tube will hold a half gallon of material so with this you can grid out your roof use 4 tubes per square (for 2 gallons per square coverage). ...

Serious Labor Savor! The Large Mouth Tip is ideal for heavy trowel grade mastics. With its 1.9" I.D., the Large Mouth Tip applies 2.5" bead in one pass and seams as fast as you can walk. Pair it with the 1/2 Gallon Roof Tube Classic

This tip is used for seam grade mastics on seams for metal, single ply's, and Mod Bit. This will leave about a 1.0" -1.5" strip on your roof.

With an I.D. of .25" this is our thinnest tip yet. Designed to be used with Rust primers, Top and Base Coats. Butter/ Seam/ or trowel grades will be too thick for this tip. NEW 3D+ Print design, a stronger more reliant model.Recommended after trying the .47 tip and it feels too messy or runny. Ideal to have in your trailer, in most instances the .47 and .625 will work fine with your favorite fastener grade product. ...

This tip is used for seam grade mastics on seams for metal, single ply's, and Mod Bit. This will leave about a 1.0" -1.5" strip on your roof.