ACRO - Roof Bracket 90°, 2" x 10" 19" Back Length, 29901

The ACRO 2″ × 10″ 90° Roof Bracket with 19″ back length is a heavy-duty, contractor-grade staging support designed to hold structurally sound 2×10 lumber planks. It exceeds OSHA standards with four offset nail slots that prevent upward slippage and is reinforced with a back-stiffening rib, six long welds, and a welded gusset for maximum strength. Smooth, rounded edges protect both workers and roofing materials, while the safety-yellow powder-coated finish ensures high visibility and resistance to wear. Engineered for clean installation and removal without shingle damage, it reliably supports one worker plus 40 lb of material per 4-ft staging section when spaced correctly.

Key Features:
• Designed for use with 2×10 planks, creating a wide and stable staging platform
• Four offset OSHA-compliant nail slots ensure secure fastening and prevent bracket movement
• Back-stiffening rib, welded gusset, and six long welds reinforce structural durability
• Smooth edges reduce risk of injury and prevent shingle damage
• Powder-coated safety-yellow finish for visibility and corrosion resistance

• Model: 29910 (2″ × 10″ Roof Bracket, 90°, 19″ back length)

• Compatible plank size: Structurally sound 2×10 lumber

• Nail slots: Four offset slots, OSHA-compliant

• Reinforcements: Welded gusset, stiffening rib, six long welds

• Load capacity: One worker plus 40 lb per 4 ft of staging

• Recommended spacing: Maximum 8 ft apart

• Finish: Powder-coated safety yellow

1. Place the bracket on the roof slope at the intended staging location over solid decking.
2. Drive nails through all four offset slots into the roof deck to secure bracket.
3. Confirm that the bracket is level and firmly seated.
4. Insert a structurally sound 2×10 plank into the heel of the bracket.
5. Continue installing brackets no more than 8 ft apart and lay planks across to form staging.
6. Verify staging platform stability and safety before use.

Q: What plank size does this bracket support?
A: It is designed for structurally sound 2×10 lumber planks.

Q: Why does the bracket include four nail slots?
A: The four offset slots exceed OSHA requirements and prevent upward slippage.

Q: Will it damage shingles during installation or removal?
A: No—the smooth, rounded edges ensure clean setup without shingle damage.

Q: How far apart should these brackets be spaced?
A: No more than 8 ft between brackets when staging with 2×10 planks.

Q: What is the load rating of this bracket?
A: Each bracket supports one worker plus 40 lb of material per 4 ft span.