ACRO - Roof Bracket 60°, 2" x 6" 16" Back Length, 26606

The ACRO 26606 Roof Bracket is a contractor-grade support bracket set at a 60° angle, featuring a 16-inch back plate optimized for use with structurally sound 2×6 lumber planks. It is engineered with four offset nail slots, surpassing OSHA’s three-slot minimum, providing resistance against upward shift. The bracket includes six long welds and a back-stiffening rib to resist twisting and flexing, plus smooth rounded edges that protect hands and roofing surfaces. Its durable powder-coated safety yellow finish enhances visibility and jobsite longevity, while its design allows for clean installation and removal without damaging shingles. When placed correctly—up to 8 ft apart—it reliably supports one worker plus up to 40 lb of materials per 4 ft staging span.

Key Features:
• Four offset nail slots for secure, OSHA-compliant placement
• Reinforced with six long welds and a back-stiffening rib for structural integrity
• Smooth, rounded edges reduce risk of injury and roof surface damage
• Installs and removes cleanly without harming shingles
• Supports one worker plus up to 40 lb per 4 ft of staging when spaced appropriately

• Model: 26606 – 2″ × 6″ Roof Bracket at 60° angle, 16″ back plate
• Compatible plank size: Use with structurally sound 2×6 lumber
• Nail slots: Four offset slots exceeding OSHA minimum
• Structural reinforcements: Back-stiffening rib and six welds
• Load capacity: One worker plus 40 lb of materials per 4 ft of staging
• Installation spacing: Maximum 8 ft between brackets
• Finish: Powder-coated safety yellow for visibility and corrosion resistance

• Position bracket at the desired staging location on the roof slope over structural decking.
• Drive nails through all four offset slots into the roof deck for a secure attachment.
• Confirm that the bracket is level and properly seated.
• Insert a straight 2×6 plank into the bracket’s heel for staging.
• Place additional brackets up to 8 ft apart and lay planks across to form staging.
• Verify stability and safety of the completed staging prior to use.

Q: What plank size does the ACRO 26606 support?
A: It supports structurally sound 2×6 lumber planks.

Q: Why are there four nail slots?
A: Four offset nail slots exceed OSHA’s requirement and prevent the bracket from sliding.

Q: Does this bracket damage shingles?
A: No—its smooth edges allow clean installation and removal without harming roofing materials.

Q: What spacing should be used for safety?
A: Maintain a maximum spacing of 8 ft between brackets when using 2×6 planks.

Q: What load can each bracket support?
A: Each bracket supports one worker plus up to 40 lb of materials per 4 ft staging span.