ACRO - Roof Bracket 45°, 2" x 6" 16" Back Length, 26456

The ACRO 26456 Roof Bracket is a contractor-grade, 45∘ angled support bracket with a 16" back plate, designed for use with sound 2×4 or 2×6 lumber scaffolding planks. It enhances safety with four offset nail slots—a number that exceeds OSHA’s requirement of three—to prevent upward sliding. For structural integrity, the bracket features six long welds and a back-stiffening rib to resist twisting and flexing under load. Its smooth, rounded edges are specifically designed to protect both the user's hands and the roofing surfaces from damage, allowing the bracket to install and remove cleanly without shingle damage. Finished in safety yellow powder coating for high visibility, this robust bracket safely supports one worker plus up to 40 lb of material per 4 ft staging when installed at the proper spacing (no more than 8 ftapart).

Key Features:
• Four offset OSHA-compliant nail slots to prevent bracket slippage
• Reinforced with six long welds and a back-stiffening rib for structural strength
• Smooth, rounded edges and corners protect hands and roofing surfaces
• Installs and removes without damaging shingles, preserving surface integrity
• Supports one worker plus up to 40 lb of materials per 4 ft when correctly spaced

• Model: 26456 – 2″ × 6″ Roof Bracket at 45° angle, 16″ back plate
• Compatible plank size: Use with structurally sound 2×4 or 2×6 lumber
• Nail slots: Four offset slots exceeding OSHA minimum
• Structural reinforcements: Six long welds, back-stiffening rib
• Load capacity: One worker + 40 lb of material per 4 ft of staging
• Installation spacing: Place brackets no more than 8 ft apart
• Finish: Powder-coated safety yellow for high visibility

• Position the bracket on the roof slope at the desired staging location, ensuring it is supported by structural substrate.
• Drive nails through all four offset slots into the roof decking for secure attachment.
• Verify that the bracket is level and securely seated.
• Insert a straight 2×4 or 2×6 plank into the bracket’s heel to complete staging.
• Install additional brackets at intervals no greater than 8 ft and lay planks across them to form a staging platform.
• Confirm stability and safety before use.

Q: What plank sizes does the ACRO 26456 support?
A: It is engineered for use with structurally sound 2×4 or 2×6 lumber planks.

Q: Why are there four nail slots?
A: The four offset nail slots exceed OSHA’s minimum requirement and prevent bracket movement.

Q: Does this bracket damage roof surfaces?
A: No—the bracket’s smooth design mitigates shingle damage during use.

Q: What spacing is recommended for safe staging?
A: A maximum of 8 ft between brackets ensures adequate support for the staging.

Q: How much load per span can it support?
A: Each bracket supports one worker plus up to 40 lb of material per 4 ft of staging.